LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column & Steering Column Switches >> Removal & Installation >> Ignition & Key Alarm Switch Assembly >> Removal & Installation ("G", "L", "M" & "U" Series)

Removal & Installation ("G", "L", "M" & "U" Series)

  1. Remove ignition lock cylinder. See LOCK CYLINDER (FUNCTIONAL) . Remove upper and lower steering column trim covers. Disconnect steering column bulkhead connector and slide turn signal and multifunction switch connectors form bulkhead connector.
  2. Using small screwdriver, gently pry retaining clip on key alarm. Rotate alarm switch 1/4 turn, and remove alarm switch. See Figure. On "U" series, pull PASS-Key® off of lock module assembly. On all models, remove 2 key alarm switch mounting screws. Remove ignition and key alarm switch assembly.
  3. To install, reverse removal procedure. Tighten ignition switch mounting screw and key alarm switch screws to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals