LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 988 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center Or Junction Block Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Adjust the instrument panel (IP) cluster trim plate for access.
  3. Disconnect the body wiring harness from the junction block.
    Fig 1: Body Wiring Harness To Junction Block
    G01737790Courtesy of GENERAL MOTORS CORP.
  4. Remove the junction block bolts.
  5. Remove the junction block tab from the slot in the cross vehicle beam. Pull the junction block away from the IP.
  6. Disconnect the body wiring harness from the junction block.
  7. Remove the junction block.
    Fig 2: Junction Block
    G01737791Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals