Terminal Removal

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Fig 1: Separating Connector Halves

Courtesy of GENERAL MOTORS CORP.

Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
Separate the connector halves (1).

Fig 2: Releasing Terminal Using Removal Tool
Courtesy of GENERAL MOTORS CORP.
Use the proper pick or removal tool (1) in order to release the terminal.
Gently pull the cable and the terminal (2) out of the back of the connector.

Fig 3: Re-Forming Locking Device

Courtesy of GENERAL MOTORS CORP.

Re-form the locking device if you are going to reuse the terminal (1).
To repair the terminal, refer to Terminal Repair .