LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Automatic Transaxle - AF33-5 (DTC P0962 - P1868)) >> Diagnostic Information & Procedures >> DTC P1868 >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step changes the AT fluid and filter. It is important to reset the oil life monitor after the fluid and filter are replaced.
DTC P1868

Step Action Values Yes No
1 Did you perform the Diagnostic System Check - Engine Controls? - Go to Step 2  Go to DIAGNOSTIC SYSTEM CHECK -- ENGINE CONTROLS
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
    3. IMPORTANT:
    • Before clearing the DTC, use the scan tool in order to record the ECM and the TCM Failure Records. Using the Clear Eng./Trans. DTC Info function erases the Failure Records from the ECM and TCM.
    • Using the Clear Eng./Trans. DTC Info function erases stored DTCs in both the ECM and TCM.
  3. Record the DTC Failure Records.
  4. Clear the DTC.
  5. Replace the transmission fluid and filter. Refer to Transmission Fluid Replacement .
  6. Use the scan tool in order to reset the transmission oil life.
Is the action complete?		 - Go to Step 3  -
3 Perform the following procedure in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Ensure that the transmission oil life monitor displays 99 percent or greater.
  4. Select Specific DTC.
  5. Enter DTC P1868.

Does the DTC reset?		 - Go to Step 2  Go to Step 4 
4 With the scan tool, observe the stored information, capture info and DTC info.
Does the scan tool display any DTCs that you have not diagnosed?		 - Go to DIAGNOSTIC TROUBLE CODE DEFINITIONS System OK
scientia non olet · About LEMON Manuals