LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Rear Drive Axle) >> Repair Instructions >> Drive Pinion Flange/Yoke and/or Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Index mark the propeller shaft at the power take-off unit (PTU) output flange and at the rear drive module input flange.
  3. Place an adjustable support at the front and the rear of the propeller shaft.
    4. Fig 1: Rear Drive Module (RDM) Propeller Shaft Guard
    GM943426Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear drive module (RDM) propeller shaft guard (2) mounting bolts (1)
    5. Fig 2: Removing/Installing Propeller Shaft Flange Mounting Bolts
    GM928922Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts securing the propeller shaft to the RDM flange.
    6. Fig 3: View Of Propeller Shaft
    GM928930Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts securing the propeller shaft to the PTU.
    7. Fig 4: View Of Propeller Shaft, Support Bearing & Bolts
    GM928924Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolts securing the support bearing to the vehicle underbody.
  8. Remove the propeller shaft from the vehicle.
    9. Fig 5: Installing J44873 On Pinion Flange
    GM1265096Courtesy of GENERAL MOTORS CORP.
  9. Install the J 44873  (1) to the pinion flange (2). See Special Tools .
  10. While holding the J 44873  with a breaker bar, loosen the pinion flange nut. See Special Tools .
    11. Fig 6: Removing Pinion Flange Nut On RDM
    GM943440Courtesy of GENERAL MOTORS CORP.
  11. Remove and discard the pinion flange nut (1).
  12. Remove the flange (2).
    13. Fig 7: Removing Dust Deflector From Drive Pinion Flange
    GM943451Courtesy of GENERAL MOTORS CORP.
  13. Remove the dust deflector (2) from the pinion flange (1).
    14. Fig 8: Removing & Discarding Pinion Oil Seal
    GM943455Courtesy of GENERAL MOTORS CORP.
  14. Remove and discard the pinion oil seal (1).
scientia non olet · About LEMON Manuals