LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 972 (Front Suspension) >> Repair Instructions >> Lower Ball Joint Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Ball Joint Rivets Using Drill
    GM933745Courtesy of GENERAL MOTORS CORP.
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Place the control arm in a vise or suitable holding device.
  3. Remove the ball joint rivets using the following procedure.
    1. Drill through the rivets using a 8 mm (5/16 in) drill bit.
    2. Enlarge the hole using a 12 mm (31/64 in) drill bit.
    3. Remove any remaining burs from the control arm.
  4. Remove the ball joint from the control arm. Note the position of the ball joint for reassembly.
scientia non olet · About LEMON Manuals