LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 968 (Exterior Trim) >> Repair Instructions >> Emblem Replacement - Front Bumper Fascia >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Emblem Front Fascia
    GM929495Courtesy of GENERAL MOTORS CORP.
  1. Install the emblem to the front fascia.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the emblem to fascia nut.

    Tighten:  Tighten the nut to 1 N.m (9 lb in).

  3. Install the front fascia. Refer to Fascia Replacement - Front Bumper .
scientia non olet · About LEMON Manuals