LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Instrument Panel Trim Pad >> Removal & Installation (Monte Carlo)

Removal & Installation (Monte Carlo)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove Instrument Panel Cluster (IPC) trim plate. Remove right-side instrument panel trim panel. Remove left-side and right-side A-pillar mouldings. Starting from right side, carefully lift upwards on defroster grille to release retainers. Disconnect Daytime Running Light (DRL) sensor from defroster grille.
  3. Remove defroster grille from vehicle. Remove upper trim pad screws. Remove remote keyless entry module. Remove instrument panel trim pad from vehicle.
  4. To install, reverse removal procedure. Tighten trim pad screws to specification. See TORQUE SPECIFICATIONS . Activate air bag system.
scientia non olet · About LEMON Manuals