LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Connecting Accessory Wire Harness
    GM965674Courtesy of GENERAL MOTORS CORP.
  1. Position the rear side trim panel to the vehicle. Place the trim under the seat belt webbing.
  2. On the driver side, connect the accessory wire harness.
  3. Push at the clip locations to secure the panel to the vehicle.
  4. Secure the weatherstrip seal over the trim edge.
  5. Install the lock pillar garnish molding. Refer to Garnish Molding Replacement - Lock Pillar Upper .
    6. Fig 2: Rear Upper Trim Molding
    GM899135Courtesy of GENERAL MOTORS CORP.
  6. Install the finish molding to the rear upper trim.
  7. Install the rear upper trim molding. Refer to Molding Replacement - Rear Window Upper .
  8. Install the carpet retainer. Refer to Carpet Retainer Replacement - Rear .
    9. Fig 3: Load Floor Storage Bin
    GM977535Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  9. Install the load floor storage bins.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

    10. Fig 4: Cargo Hooks
    GM980988Courtesy of GENERAL MOTORS CORP.
  10. Install the cargo hooks.

    Tighten:  Tighten the fasteners to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals