LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Center Pillar Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Fastener Cover To Garnish Molding
    GM977195Courtesy of GENERAL MOTORS CORP.
  1. Position the center pillar garnish molding over the lower garnish molding with the bottom tabs behind the lower molding.
  2. Gently push at the clip locations to install the garnish molding.
  3. Insert the weather-stripping over the trim edge.
  4. Install the center pin of the garnish molding fastener.
  5. Install the fastener cover to the garnish molding.
    6. Fig 2: Shoulder Belt Assembly & Fasteners
    GM964655Courtesy of GENERAL MOTORS CORP.
  6. Install the height adjuster knob.
    7. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. Install the shoulder belt assembly and fasteners.

    Tighten:  Tighten the fasteners to 50 N.m (37 lb ft).

  8. Press on the shoulder belt fastener cover until the cover snaps closed.
  9. Ensure proper operation of the seat belt.
scientia non olet · About LEMON Manuals