LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Interior Trim) >> Repair Instructions >> Finish Panel Replacement - Rear End Sill Molding >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear compartment closeout panel. Refer to Panel Replacement - Rear Compartment Closeout .
    2. Fig 1: Load Floor Storage Bin
    GM977535Courtesy of GENERAL MOTORS CORP.
  2. Remove the side stowage tray fasteners and remove the stowage tray.
  3. Remove the right passenger quarter trim. Refer to Trim Panel Replacement - Rear Quarter Lower .
    4. Fig 2: Driver Side Hold Down Hooks & Fasteners
    GM987387Courtesy of GENERAL MOTORS CORP.
  4. Remove the driver rear hold down hook fasteners and remove the hold down hooks
  5. Remove the load floor fasteners.
    6. Fig 3: Pulling On Sill Molding
    GM977526Courtesy of GENERAL MOTORS CORP.
  6. Pull upward on the sill molding to disengage the sill molding clips.
  7. Carefully slide the driver side load floor leg out from under the side trim.
    8. Fig 4: Removing Sill Molding From Load Floor Substrate
    GM987594Courtesy of GENERAL MOTORS CORP.
  8. Remove the sill molding from the load floor substrate.
scientia non olet · About LEMON Manuals