Wiring Harness Installation
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Apply automatic transmission fluid to a new transmission wiring connector O-ring seal (46).
- Install the new transmission wiring connector O-ring seal (46) onto the transmission wiring harness assembly (33).
- Install the transmission wiring harness assembly (33) into the transmission case assembly through the wiring harness bore.
- Apply automatic transmission fluid to the new transmission fluid temperature sensor O-ring seal (32).
- Install the new transmission fluid temperature sensor O-ring seal (32) into the groove of the transmission fluid temperature sensor (36).
- Install the transmission fluid temperature sensor (36) into the front control valve body fluid temperature sensor bore.
- Install the transmission fluid temperature sensor clip (49).
- Install the 1 - M6 x 1.0 x 55 mm fluid temperature sensor bolt (31).
Tighten: Tighten the fluid temperature sensor bolt to 10 N.m (89 lb in).
- Connect the 8 solenoid wire connectors as follows:
- 1 - blue
- 2 - black
- 3 - green
- 4 - black
- 5 - blue
- 6 - gray
- 7 - brown
- 8 - black
- Position the wiring harness in the wiring harness clip.