LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Torque Converter Housing Installation

Torque Converter Housing Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Case Fluid Passage Seal
    GM894637Courtesy of GENERAL MOTORS CORP.
  1. Remove the case fluid passage seal (89).
  2. Install a NEW case fluid passage seal (89) into the transmission case assembly.
    3. Fig 2: Installing Torque Converter Housing Bolts
    GM773179Courtesy of GENERAL MOTORS CORP.
  3. Apply RTV sealant to the torque converter housing assembly.
  4. Install the torque converter housing assembly to the transmission case assembly.
    5. IMPORTANT: Use LOCTITE™ 242 thread sealer on ALL bolt threads.
  5. Install the 11 - M8 x 1.25 x 30 mm bolts (1) and hand tighten.
  6. Install the 2 - M8 x 1.25 x 30 mm bolt/studs (2) and hand tighten.
  7. Install the 2 - M8 x 1.25 x 35 mm bolts (3) and hand tighten.
  8. Install the 1 - M8 x 1.25 x 45 mm bolt (4) and hand tighten.
  9. Install the 1 - M8 x 1.25 x 30 mm TORX 40 bolt (5) and hand tighten.
    10. Fig 3: Tightening Torque Converter Housing Bolts
    GM786777Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  10. Tighten the 15 torque converter housing bolts in sequence.

    Tighten:  Tighten the torque converter housing bolts to 23.5-35.3 N.m (17.33-26.00 lb ft).

scientia non olet · About LEMON Manuals