LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Third Gear Band Servo Piston Installation

Third Gear Band Servo Piston Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of 3rd Gear Band Servo Compression Spring & Piston Assembly
    GM749477Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to the third gear band servo bore in the transmission case.
  2. Install the third gear band servo compression spring (56) and the third gear band servo piston assembly (57) to the transmission case.
    3. Fig 2: View Of 3rd Gear Band Servo Cover
    GM773168Courtesy of GENERAL MOTORS CORP.
  3. Apply automatic transmission fluid to the 2 new third gear band servo cover O-ring seals (58).
  4. Install the third gear band servo cover O-ring seals (58) onto the third gear band servo cover (59).
  5. Install third gear band servo cover (59) into the third gear band servo bore in the transmission case.
    6. Fig 3: Removing 3rd Gear Servo Cover Retaining Ring
    GM749475Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the third gear band servo cover retaining ring (60) is deformed, replace it.
  6. Using snap ring pliers, install the third gear band servo cover retaining ring (60) while pressing the third gear band servo cover into the third gear band servo bore to properly seat the retaining ring.
scientia non olet · About LEMON Manuals