LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Park/Neutral Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not tip the battery over a 45 degree angle or acid could spill causing serious personal injury.
    IMPORTANT: Record all pre-set radio stations.
  1. Remove the battery. Refer to Battery Replacement .
  2. Remove the battery box. Refer to Battery Box Replacement .
  3. Fig 1: View Of Battery Tray Bracket Bolts
    GM951487Courtesy of GENERAL MOTORS CORP.
  4. Loosen the battery tray bracket screws and remove the battery tray bracket.
  5. IMPORTANT: The transaxle manual shaft must be in N (Neutral) position prior to re-installing the switch.
  6. Apply the parking brake and place control shift lever in N (Neutral).
  7. Using Fascia Retainer Remover J 36346  remove the control cable assembly from park/neutral position switch lever.
  8. Disconnect the electrical harness from park/neutral position.
  9. Remove park/neutral position switch lever and nut.
  10. Fig 2: Bending Lockwasher Tabs
    GM955494Courtesy of GENERAL MOTORS CORP.
  11. Using a screwdriver, bend the lockwasher tabs on the manual shaft nut retainer down.
  12. Fig 3: View Of Nut, Lock Tab Washer & Flat Washer
    GM955512Courtesy of GENERAL MOTORS CORP.
  13. Remove the nut, lock tab washer and flat washer.
  14. Fig 4: Removing/Installing Park/Neutral Position Switch Bolt
    GM955528Courtesy of GENERAL MOTORS CORP.
  15. Remove the park/neutral position switch bolt, stud and flat washers.
  16. Remove the park/neutral position switch.