Output Gear Assembly Removal
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate the transmission assembly so the I.D. tag is facing up.
- Remove the output gear retaining ring (48) from the output gear assembly (12).
- Remove the output gear assembly (12) from the transmission case assembly.
- Clean the output gear in solvent and air dry. Ensure the solvent is removed from the bearing.
- Inspect the bearings feel for roughness or noise.
- Inspect the gear teeth for:
- Excessive wear
- Chips or broken teeth
- Metal embedded in the teeth
- Replace the output drive gear as an assembly if any of the above conditions are found.
IMPORTANT:
Do not disassemble the output drive gear.