LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Drive Axle Shaft Seal Replacement (Right) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Right Drive Axle Seal
    GM997850Courtesy of GENERAL MOTORS CORP.
  1. Using the Differential Output Shaft Oil Seal Installer J 45187  , install the right drive axle seal onto the torque converter housing assembly. See Special Tools .
    2. Fig 2: View Of PTU
    GM945606Courtesy of GENERAL MOTORS CORP.
  2. Install the PTU onto the transaxle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the PTU bolts.

    Tighten:  Tighten the PTU retaining bolts to 60 N.m (44 lb ft).

  4. Install the front wheel drive shaft. Refer to Wheel Drive Shaft Replacement - Front in Drive Line Axle.
scientia non olet · About LEMON Manuals