LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Seat Belts) >> Repair Instructions >> Seat Belt Buckle Replacement - Front (Side Mount) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Bolt To Seat Belt Buckle
    GM981202Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.
  1. Install the seat belt buckle and the fastener to the seat adjuster.

    Tighten:  Tighten the fasteners to 45 N.m (33 lb ft).

    2. Fig 2: Seat Belt Wiring Clip & Seat Adjuster
    GM980751Courtesy of GENERAL MOTORS CORP.
  2. On the driver side, attach the seat belt wiring clip to the seat adjuster.
  3. Install the front seat in the vehicle. Refer to Seat Replacement - Front Bucket in Seats.
    4. Fig 3: Shoulder Belt Assembly & Front Seat Mini-Belt Buckle
    GM977250Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Verify that the shoulder belt is not twisted.
  4. Snap the shoulder belt assembly into the front seat mini-belt buckle.
  5. Operate the front seat shoulder belt.
scientia non olet · About LEMON Manuals