LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Seat Belts) >> Repair Instructions >> Seat Belt Buckle Replacement - Center Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion & Buckle
    GM987342Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.
  1. Route the buckle through the openings in the seat cushion.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the seat belt buckle with the fastener.

    Tighten:  Tighten the fasteners to 50 N.m (37 lb ft).

  3. Install the rear seat assembly. Refer to Seat Replacement - Rear in Seats.
scientia non olet · About LEMON Manuals