LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Seats) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement - Front Seat (4-Way) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Screw To Outer Trim Panel
    GM981027Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Position the outer trim panel on the seat. Secure the panel with the panel screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    2. Fig 2: Recliner Handle Trim
    GM981017Courtesy of GENERAL MOTORS CORP.
  2. Position the cover over the recliner handle. Push firmly to lock the handle into place.
    3. Fig 3: Seat Riser Handle Trim
    GM981011Courtesy of GENERAL MOTORS CORP.
  3. Position the cover over the seat riser handle. Push firmly to lock the handle into place.
  4. Install the front seat. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals