LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Seats) >> Repair Instructions >> Seat Back Latch Release Cable Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Replacing Cable Out Of Seat Back Assembly
    GM986695Courtesy of GENERAL MOTORS CORP.
  1. If you are replacing the cable, route the cable through the rear seat back.
    2. Fig 2: Disconnecting/Connecting Seat Recliner Cable
    GM987263Courtesy of GENERAL MOTORS CORP.
  2. Connect the latch cable to the recliner mechanism.
    3. Fig 3: Seat Back Recliner Handle & Cable
    GM986676Courtesy of GENERAL MOTORS CORP.
  3. Connect the J-strip at the bottom of the seat cover.
  4. Connect the latch cable to the latch assembly.
    5. Fig 4: Installing Fastener From Rear Seat Back Latch
    GM982101Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the latch to the seat back with a fastener.

    Tighten:  Tighten the fastener to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals