LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Seats) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front (Non-Fold Flat) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the outer trim panel from the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat (4-Way)  or Seat Cushion Outer Trim Panel Replacement - Front Seat (2-Way) .
  3. Remove the armrest from the seat. Refer to Armrest Replacement - Front Seat .
    4. Fig 1: Disconnecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  4. On vehicles with heated seats, disconnect the electrical connector from the seat heat module.
  5. Remove the head restraint. Refer to Head Restraint Replacement - Front Seat .
    6. Fig 2: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the lower J-hook retainer from the seat back trim cover.
  7. Carefully pull up on the trim cover, disengaging the hook and loop retainers, until the head restraint guides are exposed.
    8. Fig 3: Removing/Installing Headrest Guides
    GM981023Courtesy of GENERAL MOTORS CORP.
  8. Squeeze the locking tabs on the head restraint guide. Push the guides up and out of the seat back pad, cover, and frame.
  9. Remove the seat back trim cover from the seat.
  10. Remove the seat back pad from the frame.
scientia non olet · About LEMON Manuals