LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Power Seat System) >> Repair Instructions >> Seat Back Replacement - Rear (Stationary) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear seat back to the vehicle.
  2. Hook the seat back upper frame to the hangers on the rear shelf.
    Fig 1: Installing Rear Seat Back
    G01617359Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the rear seat back nuts to the latch bracket.

    Tighten 

    Tighten the rear seat back nuts to 10 N.m (89 lb in).

  4. Install the rear seat cushion. Refer to Seat Cushion Replacement - Rear .
    Fig 2: Rear Seat Back
    G01617360Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals