LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Power Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Rear (Folding) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fold down seat backs on the seat back frame.
    Fig 1: Position Fold Down Seat Backs On Seat Back Frame
    G01617369Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts (1) on the seat back frame.

    Tighten 

    Tighten the bolts to 10 N.m (89 lb in).

  3. Install the rear seat back bolsters. Refer to Seat Back Bolster Replacement - Rear Split Folding .
  4. Install the rear seat back. Refer to Seat Back Replacement - Rear (Stationary)  or Seat Back Replacement - Rear (Folding) .
    Fig 2: Seat Back Frame Bolt
    G01617370Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals