LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Power Seat System) >> Diagnostic Information and Procedures >> Seat - Back Lock Diagnosis >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Back Lock Diagnosis
G01617270Courtesy of GENERAL MOTORS CORP.
  1. Remove the seat from the vehicle.

    Place the seat on a clean surface, with the seat facing right side up.

  2. Raise the rear of the seat until the seat back center of gravity passes through vertical and the seat back begins to fold.

    The inertia seat back lock should engage allowing only a few degrees of travel.

  3. If the seat back inertia lock did not engage, replace the inertia lock. Refer to Inertia Latch Replacement .
  4. If the inertia has properly engaged, activate the release lever (2) and allow the seat to fold forward.
scientia non olet · About LEMON Manuals