LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 929 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Front Toe Adjustment

Front Toe Adjustment

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering gear seal small clamps.
  2. Verify that the steering wheel is centered and the wheels are in the straight ahead position.
    3. Fig 1: Tie Rod Jam Nuts
    G01828285Courtesy of GENERAL MOTORS CORP.
  3. Loosen the left and right tie rod jam nuts (2).
    IMPORTANT: Verify that the number of threads showing on both inner tie rod ends are approximately equal.
  4. Rotate the inner tie rods in order to obtain the proper toe angle of 0 degrees.
    NOTE: Refer to FASTENER NOTICE .
  5. Install the tie rod end jam nuts.

    Tighten 

    Tighten the left and right tie rod jam nuts (2) to 68 N.m (50 lb ft).

    IMPORTANT: Verify that the power steering gear seal is not twisted.
  6. Install the power steering gear seal small clamps.
scientia non olet · About LEMON Manuals