LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 927 (Rear Drive Axle) >> Repair Instructions >> Drive Pinion Flange/Yoke and/or Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new pinion housing assembly oil seal with synthetic gear oil GM P/N United States 12378514 Canada P/N 88901045 or equivalent.
  2. Use the J 44915  in order to install a new oil seal (2) to the drive pinion housing.
  3. Install the torque tube assembly. Refer to Torque Tube Assembly Replacement .
  4. Inspect the differential carrier lubricant level. Refer to Lubricant Change .
    Fig 1: Installing Torque Tube Assembly
    G01827289Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals