LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 925 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Roof Weld Joint Reveal (With Out B4U) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. To remove the roof weld joint molding, use Kent special release agent spray along inside and outside of the molding. Allow to set for 5 minutes.
    NOTE: Refer to EXTERIOR TRIM EMBLEM REMOVAL NOTICE .
  2. To remove the weld joint molding from the roof, begin at one end using a small plastic flat-bladed tool. Lift the weld joint molding away from the weld joint.
  3. Remove all adhesive from the weld joint using 3MTM Scotch Brite molding adhesive remover disk 3MTM P/N 07501 or equivalent.
  4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
    Fig 1: Removing Roof Weld Joint Molding
    G01616751Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals