LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear compartment lid lock striker to the rear compartment body panel.
  2. Install the bolts in the rear compartment lid lock striker under the rear bumper fascia.
  3. Tighten the bolts part way allowing for the adjustment of the rear compartment lid lock striker.
  4. Close the rear compartment lid in order to set the adjustment of the compartment lid.
    NOTE: Refer to FASTENER NOTICE .
  5. Tighten the rear compartment lid lock striker bolts.

    Tighten 

    Tighten the rear compartment lid lock striker bolts to 16 N.m (12 lb ft).

  6. Install the bolt to the rear compartment lid lock striker bolts to 16 N.m (12 lb ft).
  7. Install the bolt to the rear compartment lid lock striker in the rear compartment.
    Fig 1: Rear Compartment Lid Lock Striker
    G01617512Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Due to sealer squeeze out on the rear compartment lid lock striker bolts, inspect the fastener tightening specifications at least 2 times.

    Tighten 

    Tighten the rear compartment lid lock striker bolt to 16 N.m (12 lb ft).

  8. Install the rear bumper fascia. Refer to FASCIA REPLACEMENT -- REAR BUMPER .
  9. Install the rear compartment trim panels. Refer to Compartment Trim Panel Replacement - Rear .
  10. Close the rear compartment.
scientia non olet · About LEMON Manuals