LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Power Seat System) >> Repair Instructions >> Seat Adjuster Track Cover Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the front seat adjuster switch to the finish cover, if equipped.
  2. Install the finish covers to the front seat frame.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the finish cover screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  4. Install the cup holder, if equipped. Refer to Cupholder Replacement - Front Seat .
  5. Install the map pocket net attachment, if equipped. Refer to Map Pocket Net Replacement - Front Seat .
    Fig 1: Installing Finish Covers To Front Seat Frame
    G01814296Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals