LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Power Seat System) >> Repair Instructions >> Cupholder Replacement - Rear Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cup holder.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the cup holder screws.

    Tighten 

    Tighten the screws to 9 N.m (80 lb in).

  3. Fold the cup holder to its closed position.
    Fig 1: Installing Cup Holder & Screws (Rear Seat)
    G01814444Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals