LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Power Seat System) >> Repair Instructions >> Armrest Replacement - Rear Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the armrest to the seat.

    Important:  During the removal of the armrest, ensure that you reset the C-clip (open end facing down) into the slotted shaft if the armrest C-clip disengages from the slotted shaft.

  2. Press firmly inward on the armrest in order to seat the C-clip onto the armrest pivot shaft.
  3. Install the J retainer at the bottom edge of the seat back cover.
  4. Install the rear seat. Refer to Seat Replacement - Rear .
  5. Reposition the seat back to the original position.
    Fig 1: Installing Armrest, C-Clip & Pivot Shaft (Rear Seat)
    G01814440Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals