LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 909 (Heating, Ventilation & Air Conditioning) >> Repair Instructions >> Service Ports Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Important:  DO NOT allow any of the mineral base 525 viscosity refrigerant oil on the new O-ring to enter the refrigerant system.

  1. Lightly coat the O-ring with mineral base 525 viscosity refrigerant oil.
    NOTE: Refer to FASTENER NOTICE .
    2. Fig 1: Service Ports
    G01827878Courtesy of GENERAL MOTORS CORP.
  2. Install the service port.

    Tighten 

    Tighten the service port to 11 N.m (98 lb in).

  3. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  4. Leak test the fittings of the component using J 39400-A. 
  5. Install the service port cap.

    Tighten the cap 1/4-1/2 turn after the seal washer contacts to access fitting.

scientia non olet · About LEMON Manuals