Repairs and Inspections Required After a Collision: Notes
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Proper operation of the Supplemental Inflatable Restraint (SIR) sensing system requires that any repairs to the vehicle structure return the vehicle structure to the original production configuration. Not properly repairing the vehicle structure could cause non-deployment of the air bag(s) In a frontal collision or deployment of the air bag(s) for conditions less severe than intended.
After any collision, inspect the following components as indicated. If damage is detected, replace the component. If damage to the mounting points or mounting hardware is detected, repair the component or replace the hardware as needed.
- Steering column - Perform the steering column accident damage inspection procedures. Refer to STEERING COLUMN ACCIDENT DAMAGE INSPECTION -- OFF VEHICLE .
- IP Knee Bolsters and Mounting Points - Inspect the knee bolsters for bending, twisting, buckling, or any other type of damage.
- IP brackets, braces, etc. - Inspect for bending, twisting, buckling, or any other type of damage.
- Seat Belts - Perform the seat belt operational and functional checks. Refer to OPERATIONAL AND FUNCTIONAL CHECKS .
- IP Cross Car Beam - Inspect for bending, twisting, buckling, or any other type of damage.
- IP Mounting Points and Brackets - Inspect for bending, twisting, buckling, or any other type of damage.
- Seats and Seat Mounting Points - Inspect for bending, twisting, buckling, or any other type of damage.