LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 903 (Anti-Lock Brake System) >> Repair Instructions >> ABS Automated Bleed Procedure >> Automated Bleed Procedure >> Preliminary Setup

Preliminary Setup

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and vehicle on a suitable support. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Turn the ignition switch to OFF position.
  3. Remove all four tires, if necessary Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  4. Connect the pressure bleeding tool according to the manufacturer's instructions.
  5. Turn the ignition switch to RUN position, engine off.
  6. Connect a scan tool and establish communications with the ABS system.
  7. Pressurize the bleeding tool to 206 to 241 kPa (30 to 35 psi).
scientia non olet · About LEMON Manuals