LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 898 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim plate to the I/P.
  2. Install the trim plate by pressing in at each retainer location until seated correctly.
  3. Return the steering column to the original position.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screw to right end of the trim plate.

    Tighten 

    Tighten the screw to 2 N.m (18 lb in).

    Fig 1: Installing Screw To Right End Of Trim Plate
    G01587471Courtesy of GENERAL MOTORS CORP.
  5. Install the filler panel to the lower section of the I/P. Refer to FILLER PANEL REPLACEMENT - OUTER -INSTRUMENT PANEL (I/P) LOWER TRIM  .
  6. Close the I/P compartment.
  7. Install the outer trim covers by pressing each cover into place until seated correctly.
    Fig 2: Installing Outer Trim Covers
    G01587472Courtesy of GENERAL MOTORS CORP.
  8. If equipped with column shift, adjust the shift lever to PARK.
  9. Install the front floor console, if equipped. Refer to CONSOLE REPLACEMENT - FRONT FLOOR (D06)  .
  10. Install the accessory trim plate, if not equipped with a front floor console. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY  .
  11. Install the steering column filler panel. Refer to STEERING COLUMN FILLER REPLACEMENT  .
  12. Release the park brake.
scientia non olet · About LEMON Manuals