LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 898 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the cluster.
    Fig 1: Connecting Electrical Connector To I/P Cluster
    G01587500Courtesy of GENERAL MOTORS CORP.
  2. In order to install the IPC, perform the following procedures:
    1. 2.1. Rotate the top of the cluster forward.
    2. 2.2. Engage the locating pins on the bottom of the cluster.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screws to the IPC.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

    Fig 2: Installing Screws To I/P Cluster
    G01587501Courtesy of GENERAL MOTORS CORP.
  4. Install the IPC trim plate. Refer to TRIM PLATE BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER  .
scientia non olet · About LEMON Manuals