LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Bumper System) >> Repair Instructions >> Splash Shield Replacement - Rear Bumper Fascia >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the rear bumper fascia splash shield to the rear bumper fascia.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the rear bumper fascia splash shield screws to the rear bumper fascia splash shield.

    Tighten 

    Tighten the rear bumper fascia splash shield screws to 2 N.m (19 lb in).

  3. Install the push-in the retainer to the lower rear bumper fascia splash shield.
    Fig 1: Installing Push-In Retainer & Lower Rear Bumper Fascia Splash Shield
    G01813801Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals