LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Bumper System) >> Repair Instructions >> Fascia Reflector Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use a heat gun to heat the rear bumper fascia reflectors. Hold the heat gun 152 mm (6 in) from the surface.
  2. Use a circular motion for 30 seconds when applying heat to the surface.

    Important:  Be careful not to scratch paint with the flat-bladed tool.

  3. Use a flat-bladed tool to peel the rear bumper fascia reflectors from the rear bumper fascia surface.
  4. Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.
scientia non olet · About LEMON Manuals