Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Warm the rear bumper fascia with a heat lamp or heat gun to a minimum of 21.C (70.F).
Important: DO NOT touch the adhesive backing.
- Peel the backing from the front end of the rear bumper fascia reflectors.
- Press the rear bumper fascia reflectors to the rear fascia while continuing to remove the backing.
- Hand roll the rear bumper fascia reflectors to the rear fascia in order to ensure proper adhesion.