Weld Stud Replacement
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
If a weld stud is damaged during a repair procedure, perform the following steps in order to replace the weld stud:
CAUTION:
Refer to SAFETY GLASSES CAUTION
.
- Drill a hole into the same location as the damaged weld stud.
- Drive a screw into the drilled hole.
- Use a screw to retain the following components:
- The clips
- The moldings
- Other components
- If the surface is damaged, repair and paint the surface as needed in order to provide a smooth surface.