Removal Procedure
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Battery.
- Remove the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L36) or FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L67) in Engine Mechanical - 3.8L.
- Remove the engine mount struts. Refer to ENGINE MOUNT STRUT REPLACEMENT - RIGHT and ENGINE MOUNT STRUT REPLACEMENT - LEFT in Engine Mechanical - 3.8L.
- Remove the lower right engine mount strut bracket. Refer to ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT LOWER in Engine Mechanical - 3.8L.
- Remove the exhaust crossover pipe bolts from the left exhaust manifold.
- Remove the left spark plugs from cylinders 1, 3 and 5. Refer to SPARK PLUGS in Self-Diagnostics - 3.8L.
- Remove the oil level indicator tube. Refer to OIL LEVEL INDICATOR AND TUBE REPLACEMENT in Engine Mechanical - 3.8L.
- Remove the left engine lift bracket bolt and the nut.
- Remove the left engine lift bracket
- Remove the exhaust manifold heat shield nuts.
- Remove the exhaust manifold heat shield.
- Remove the exhaust manifold bolts and the nuts.
- Remove the exhaust manifold.
- Remove the exhaust manifold gasket.
- Clean and inspect the left exhaust manifold. Refer to EXHAUST MANIFOLD CLEANING AND INSPECTION in Engine Mechanical - 3.8L.