LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Positive Crankcase Ventilation (PCV) Valve Replacement (L67) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new O-ring (3), the spring and the PCV valve (2).
    Fig 1: Installing PCV Valve, Access Cover & Bolts (L67)
    G01968395Courtesy of GENERAL MOTORS CORP.
  2. Install the PCV valve access cover (1).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. While holding down on the PCV valve access cover, install the access cover bolts.

    Tighten 

    Tighten the bolts to 10 N.m (89 lb in).

  4. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L36)  or FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L67)  .
scientia non olet · About LEMON Manuals