LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pump Pipe and Screen Assembly Installation

Oil Pump Pipe and Screen Assembly Installation

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pump pipe and screen assembly gasket.
    IMPORTANT: The oil pan gasket must be installed before the oil pump pipe and screen assembly.
  2. Install the oil pan gasket.
  3. Install the oil pump pipe and screen assembly.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the oil pump pipe and screen assembly bolts.

    Tighten 

    Tighten the bolts to 15 N.m (11 lb ft).

    Fig 1: Installing Oil Pump Pipe & Screen Assembly
    G01969483Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals