LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Flywheel Installation

Engine Flywheel Installation

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 36660-A  Torque Angle Meter. See Special Tools and Equipment .

  1. Install the flywheel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the new flywheel bolts.

    Tighten 

    Tighten the bolts to 15 N.m (11 lb ft). Use the J 36660-A  to tighten the bolts an additional 50 degrees.

    Fig 1: Installing Engine Flywheel & Bolts
    G01969532Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals