LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Drive Belt Tensioner Installation

Drive Belt Tensioner Installation

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt tensioner bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the drive belt tensioner bracket bolts.

    Tighten 

    Tighten the drive belt tensioner bolts to 50 N.m (37 lb ft).

    Fig 1: Installing Drive Belt Tensioner Bracket & Bolts
    G01969530Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals