LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 887 (Engine Mechanical - 3.1L V6 - VIN (J)) >> Repair Instructions >> On-Vehicle repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE Battery.
  2. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  3. Disconnect the engine oil pressure sensor electrical connector.
  4. Remove the engine oil pressure sensor.
    Fig 1: Removing Engine Oil Pressure Sensor
    G01967922Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals