LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 881 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam and Upper Bearing Thrust Washer >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in Air Bag Restraint Systems.
    IMPORTANT: Let the SIR coil hang freely after removal.
  2. Remove the SIR coil. Refer to SIR COIL ASSEMBLY in Air Bag Restraint Systems.
  3. Remove and discard the bearing retainer using J 23653-SIR  and J 42137  .
    Fig 1: Removing Bearing Retainer Using J 23653-SIR & J 42137
    G01569305Courtesy of GENERAL MOTORS CORP.
  4. If standard column, remove the following parts from the steering shaft assembly:
    1. 4.1. The cam orientation plate (4)
    2. 4.2. The turn signal cancel cam assembly (3)
    3. 4.3. The upper bearing spring (2)
    4. 4.4. The thrust washer (1)
    Fig 2: Exploded View Of Standard Steering Column Components
    G01569306Courtesy of GENERAL MOTORS CORP.
  5. If tilt column, remove the following parts from the steering column shaft assembly:
    1. 5.1. The cam orientation plate (5)
    2. 5.2. The turn signal cancel cam assembly (4)
    3. 5.3. The upper bearing spring (3)
    4. 5.4. The upper bearing inner race seat (2)
    5. 5.5. The inner race (1)
    Fig 3: View Of Tilt Steering Column Components
    G01569307Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals