Removal & Installation (Van)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 GMC C3500 HD, and 2002 Chevrolet RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cables. Remove the harness connector from the Crankshaft Position (CKP) sensor by releasing the locking tab. Remove the CKP sensor mounting bolt. Remove the sensor from the engine. See Fig 1. To install, reverse removal procedure. Tighten fasteners properly. See TORQUE SPECIFICATIONS .