Removal & Installation (Van)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 GMC C3500 HD, and 2002 Chevrolet RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove the fuel tank filler cap. Remove the protective shield from fuel manager/filter. Open the air bleed valve on top of the fuel manager/filter in order to release any pressure in the fuel supply system. Disconnect the sensor wiring connector by pulling straight down. Remove the water-in-fuel sensor by turning counterclockwise.
- Install water-in-fuel sensor and seal. Reconnect the sensor connector. Install the protective shield. Bleed the air from the fuel manager/filter if necessary. Install fuel tank filler cap. Tighten fasteners properly. See TORQUE SPECIFICATIONS . Lower the vehicle.